How To Tie In A New Roof To An Existing Roof

How To Tie In A New Roof To An Existing Roof

How To Tie In A New Roof To An Existing Roof. The big idea is that layers of the lower roof should sit below corresponding layers of the upper roof. Adding a gable roof to an existing roof.

How To Tie In A New Roof To An Existing RoofHow To Tie In A New Roof To An Existing Roof
How To Tie A Shed Roof Into An Existing Roof saintjohn from

The old garage has no. The addition consists of adding a bathroom suite and an octagonal sitting area to the corner of the home. For the first two types of projects, start by nailing a new truss to the end truss of the old roof or to the wall of the house.

The Easiest Way To Tie In The New Shingles With The Old Is With A Cut Valley (See Four Ways To Shingle A Valley).

When the top of a roof is worn out, it will leave the framing intact. To do this, we had to extend the plane of the shed roof out over the porch roof, creating a small triangular extension of the existing roof. The bottom of our blind valley was about 30 inches short of the bottom of the porch roof, so we extended the line of the valley down to the edge of the new roof.

Frame And Sheathe The Addition Roof, And Snap A Line On The Existing Shingles 2 Inches Above The Valley.

I am wanting to add on to my existing garage with the roof of the new garage perpindicular to the old garage. After the addition roof is framed and sheathed, snap a line on the existing roof shingles 2 in. The roofing cement will resist possible leaks overnight.

As It Turned Out, The Existing Roof Structure Is A Truss System, But They Were Able To Contact The Original Truss Manufacturer To Verify That Cutting The Tails Off Would Not Jeopardize The Structural Integrity Of.

The old garage has no. See more ideas about patio roof, backyard patio, patio. Knowing local building codes avoid further hassles before you start your project, you should know about the local building codes and other permit requirements.

The Addition Consists Of Adding A Bathroom Suite And An Octagonal Sitting Area To The Corner Of The Home.

How to tie into existing roof shingles. The new flashing should go under the old felt and over the new felt and new roll roofing. To tie into the side of an existing roof, put a new roof truss on the walls of the addition, brace it upright, then snap chalk lines on the shingles to mark the center line of the new roof valleys, where old and new roofs will connect.

Tying In To An Existing Gable Roof.

Are there any videos or help books on tying the new gable roof to the old roof? Depends on the slope of the new roof. Step by step guide to tie porch roof to existing roof step 1:

Posted in DIY

Tags - Existing